3-Pin To 5-Pin Conversion Chart; Setting Up Admx Serial Data Link; Mounting; Operating Instructions - Chauvet Data Stream 4 User Manual

3-Pin to 5-Pin Conversion Chart

Note! If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin
adapter. CHAUVET® Model No: DMX5M, or DMX5F.
The chart below details a proper cable conversion:
3 P 5 P
IN TO IN
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of
the DMX cable to the output (female) 3 pin
connector of the controller.
2. Connect the end of the cable coming from
the controller which will have a (female) 3
pin connector to the input connector of the
next fixture consisting of a (male) 3 pin
connector.
3. Then, proceed to connect from the output
as stated above to the input of the following
fixture and so on.
CHAUVET® Certified DMX Data Cables
Order Code
DMX1.5
DMX4.5
DMX10

Mounting

Orientation & Rigging
This fixture may be mounted in any position provided there is adequate room for ventilation.
It is important never to obstruct the vents pathway. Mount the fixture using, a suitable "C" or "O" type
clamp.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.

Operating Instructions

This is DMX splitter, and it is designed to distribute/boost the incoming DMX signal into 4 separate
outputs. Each of the 4 outputs is electronically isolated from the others (with the exception of the
"thru" or "link" output) and each output has 3- and 5-pin XLR sockets.
Follow all DMX standards when using this device.
Date Stream™ 4 User Manual
C C
ONVERSION HART
3 Pin Female (output)
Pin 1
Pin 2
Pin 3
Description
DMX Cable 1.5m/4.9ft
DMX Cable 4.5m/14.8ft
DMX Cable 10m/32.8ft
6
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
Universal DMX Controller
2/8/2012 5:06 PM