Table of Contents
Advertisement
IP Mode
The IP address of the Maverick MK1 Spot can be set manually, by the network, or to a pre-set static
address specific to each product. To set the IP Mode, follow the instructions below:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
5.
If using the buttons instead of the touchscreen, press <ENTER>.
6.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
Manual (set the IP address with the control panel),
DHCP (the network sets the IP address),
or
Static (a pre-set address specific to each product),
or touch the display where it says the desired mode.
7.
Press <ENTER>.
Universe
The Universe must be assigned through the product menu. To set the Universe do the following:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
5.
If using the buttons instead of the touchscreen, press <ENTER>.
6.
Enter the universe address (0–254 for ArtNet, 0–255 for sACN) with one of the following
methods:
Type the universe number using the number pad that shows on the touchscreen display.
or
Using the buttons (or the button icons on the sides of the display),
a.
Use <LEFT> or <RIGHT> to select the digit to be altered.
b.
Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c.
Repeat until the universe or subnet is set as desired.
Page 16 of 38
Maverick MK1 Spot User Manual Rev. 1
O
PERATION
Advertisement
Table of Contents
