15-24
1972 PONTIAC SERVICE MANUAL
CAUTION: D O N O T LOOSEN OR REMOVE-
FACTORY ADJUSTED
POINT A D J ~ S T I N G
L ~ W
SPEED
SCREW
SWITCH
Fig. 15-19 Adjusting Low Speed Switch
5. Slide the governor assembly away from the speedom-
eter drive adapter end until the shaft is free of bear-
ing. This will allow the governor assembly to
be
removed from the regulator. For further disassembly
of governor, see Fig. 15-1 8.
6. Remove four screws (2 internal, 2 external) holding
the valve body and magnet assembly. Remove valve
Fig. 1 5 - 2 0 Cover and Intake Filter Assembly
body and magnet assembly from the regulator hous-
ing. (Fig. 15-23).
7. Remove driven gear from regulator by pressing re-
taining pin out of regulator body.
ACTUATOR PIN
1
L
GOVERNOR SPRING
BEARING S U P P O R T
A S S E M B L Y
a
Fig. 15-2 1 Bearing Support Removal