7F-32
1972 PONTIAC SERVICE MANUAL
Fig. 7F-50 Removing Governor Valve and Shaft
3. If necessary to replace, pry rear oil seal from exten-
sion housing.
4. Depress retaining clip and slide speedometer drive
gear from clip and output shaft (Fig. 7F-49).
Fig. 7F-5 1 Removing Governor Assembly
Fig. 7F-52 Removing Oil Pump Assembly
5. On the weight side of governor, remove
"E"
clip from
governor shaft and remove governor shaft and valve
from opposite side of governor (Fig. 7F-50).
6.. Remove urethane washer (located between governor
weight and output shaft) from governor body.
7. Loosen drive screw from governor hub and remove
governor assembly from output shaft (Fig. 7F-5 1).
8.
Remove four (4) governor support-to-case bolts,
drain-back baffle, governor support and its gasket
from transmission case and output shaft.
9. If necessary, unscrew pressure switch from side of
servo boss on transmission case.
INTERNAL COMPONENTS
REMOVE
1. Remove seven (7) oil pump attaching bolts. The bolt
holes are offset to facilitate proper location of pump
upon installation.
2. Install Slide Hammers J 6125 with Adapters J 6125-2
into two (2) threaded bolt holes of the pump body (at
4 and 10 o'clock), loosen and remove oil pump and
stator shaft assembly from case (Fig. 7F-52).
3. Remove oil pump gasket from case (or pump) and
remove tanged selective fit thrust washer from pump
cover.
4. Back off band anchor adjusting screw to release ten-
sion on low brake band. Grasp input shaft and care-
fully work it and clutch assembly out of transmission