Pontiac FIREBIRD 1972 Service Manual page 1083

TURBO HYDRA-MATIC (M-38) TRANSMISSION 76-45
Fig. 7G-64 Removing Case-to-Support Retaining Ring
8. Remove input ring gear (Fig. 76-61).
9. Remove input ring gear-to-output carrier thrust
washer from ring gear (or output carrier). This'
washer has four (4) external tangs.
10. Using a finely pointed awl and a small screwdriver,
remove output carrier-to-output shaft snap ring. Dis-
card ring.
11. Remove output carrier assembly (Fig. 76-62).
12. Remove sun gear drive shell assembly (Fig. 76-63).
13. Remove sun gear drive shell-to-low and reverse roller
clutch inner race thrust washer from drive shell (or
Fig. 7G-66 Removing Retainer Spring
inner race). This washer has four (4) wide internal
tangs.
14. Remove low and reverse roller clutch support-to-case
retaining ring (Fig. 76-64).
15. Push up on end of output shaft until the low and
reverse clutch support assembly clears the low and
reverse clutch support retainer spring. Then, remove
the low and reverse clutch support assembly from the
case (Fig. 76-65).
16. Remove low and reverse clutch support retainer
spring (Fig. 76-66), push up on end of output shaft-
and remove output shaft assembly from case.
OUTPUT RING GEAR
A N D
SHAFT ASSEMBLY
T l O N CARRIER
Fig. 7G-65 Location ,of Retainer Spring
Fig. 7G-67 Removing Carrier from Shaft