Pontiac FIREBIRD 1972 Service Manual page 1179

9-26 1972 PONTIAC SERVICE MANUAL
S P R I N G LATCH
Fig. 9-28 Installation of Lock Cylinder
cylinder sleeve aligned to keyway in housing. Push
into abutment of cylinder and lock sector.
4. Rotate lock knob counterclockwise. Maintaining a
light push inward on lock cylinder until drive section
of lock cylinder mates with sector.
5. Push in until spring latch pops into groove and lock
cylinder is secured into the housing.
6. Remove 1/16" drill.
7. Check freedom of rotation of lock cylinder in hous-
ing. There must be a free spring return from
"START" to "RUN" positions.
CAUTION: Ifprior to assembly ofback-up light
and/or neutral-start switch, the lock should re-
main in the "RUN
"
position.
8. Install turn signal switch (see TURN SIGNAL
SWITCH
-
INSTALL).
9. Install steering wheel (see STEERING WHEEL
-
INSTALL).
BUZZER SWITCH
REMOVE
1. Remove steering wheel (see STEERING WHEEL
-
REMOVE).
2. Pull turn signal switch up far enough to allow access
to buzzer switch (see TURN SIGNAL SWITCH
-
REMOVE, steps 2 through 9).
3. Pull buzzer switch straight out of the housing using
a paper clip or similar tool. A flat spring wedges the
switch toward the lock cylinder (Fig. 9-29).
NOTE: This may be done without the removal
of the lock cylinder. I f the lock cylinder is in the
housing, it must be in the "RUN
"
position.
CAUTION: Be careful not to let flat s p h g fa//
down into housing and do not pull on switch
contacts or plastic m a t e d of switch when
removing.
INSTALL
1. Assemble buzzer switch to spring clip with formed