1972 PONTIAC SERVICE MANUAL
Fig. 12-87 X Series Printed Circuit and Fuel Gage Installation
6. Disconnect dimmer switch, door jamb switch, park-
12. To replace instrument panel, reverse removal proce-
ing brake switch, stop lamp switch, neutral safety
dure.
switch, back-up lamp switch, body harness, ignition
switch and air conditioning harness.
G SERIES
7. Disconnect vacuum harness and temperature control
1. Disconnect battery.
cable at control panel.
2. Remove lower air conditioning ducts if so equipped.
8. Lower steering column and disconnect speedometer
cable.
3. Separate bulkhead connector and disconnect neces-
sary wires at horn relay.
9. Remove upper screws at gages, nuts at upper right
end and lower attaching screws.
4. Remove plastic toe plate at steering column and
remove two fuse block screws.
10. Remove complete assembly from car and transfer
remaining parts while at bench.
5. Remove left air outlet nozzle and air conditioning
duct extension.
11. Transfer of parts at bench includes clock, cluster,
instrument panel harness, air conditioning duct ex-
6. Disconnect the following
-
dimmer switch, park
tensions and air outlet nozzles, control panel, all swit-
brake switch, stop lamp switch, neutral safety switch,
ches and miscellaneous trim and retaining parts.
transmission downshift switch, left door jamb switch,