CHASSIS ELECTRICAL
12-85
I N ~ E R
APPLIQUE
\
R.H. APPLIQUE
Fig. 12-96 G Series Instrument Panel Pad Attaching Parts
2.
Remove pillar post moldings and filler plate at wind-
9. Remove instrument panel bulbs at left end.
shield.
3. Remove lower instrument panel trim at steering col-
umn.
4. Disconnect speedometer cable.
5.
Lower steering column.
6. Remove upper air outlet vents and instrument panel
attaching screws at steering column, console, ends
and upper center.
7. Remove lower defroster duct screw.
8.
Position crash pad rearward on steering column.
10.
Remove gage terminal nuts and fuel gage attaching
screws.
11.
Lift end of printed circuit carefully and remove gage.
12. To replace, reverse removal procedure.
F SERIES
-
STANDARD CLUSTER
1.
Remove speedo cluster and printed circuit as previ-
ously described under F Series.
2.
Remove fuel gage nuts and gage.