CHASSIS ELECTRICAL
12-61
SIDE MARKER
LAMP ASM.
- -
Fig. 12-67 Endura Bumper and GTO Front Lamps Installation
FRONT PARK/TURN SIGNAL LAMP
HOUSING ASSEMBLY
REMOVE AND REPLACE
All except
G
Series (Figs. 12-65, 66, 67, 69
and
70)
1. Remove screws from lamp assembly to headlamp
filler panel or valance panel.
2. Remove lamp assembly and twist bulb and socket
from assembly.
3. To replace, reverse the removal procedure.
G SERIES (Fig. 12-68)
1. Remove lens.
2. Remove lamp retaining screws.
3. Pull lamp assembly and disconnect wires.
4.
To replace reverse removal procedure.
FRONT PARK AND SIGNAL LAMP LENS
REMOVE AND REPLACE
G SERIES
1. Remove 2 retaining screws from lens and housing.
A, B, F AND X SERIES
Due to the construction of these lamps, lens is not ser-
viced, therefore, lamp housing must be replaced.
HORNS
REMOVE AND REPLACE
1. A, B
and
G Series
-
Remove upper radiator shroud
bolts, tilt radiatorhhroud assembly toward engine
for access.
F Series
-
Reach thru opening between bumper and
support.
X Series
-
Remove windshield washer solvent con-
tainer from left front fender.