Pontiac FIREBIRD 1972 Service Manual page 1104

76-66 1972 PONTIAC SERVICE MANUAL
b. Using Bushing Tool J 23062-3 and Drive Handle
J 8092, install new bushing flush to .01OV below
inside face (Fig. 7G-121).
6. Check reaction carrier pinion end play. Should be
.009" to .ONv.
7. Inspect reaction carrier bushing for nicks, scoring or
wear. If bushing is damaged, replace as follows:
a. Using Bushing Tool J 23062-3 and Drive Handle
J 8092 and with reaction carrier properly sup-
ported, drive out bushing (Fig. 7G-121).
OUTPUT RlNG GEAR A N D OUTPUT
SHAFT
INSPECT
1. Wash in cleaning solvent and air dry.
2. Check output ring gear for tooth damage.
3. Inspect output ring gear and output shaft splines for
nicks or damage.
4. Check output shaft bearing surface for nicks or scor-
ing.
5. Check output shaft bushing for nicks, scoring or
wear. If bushing is damaged, replace as follows:
a. Thread Bushing Tool J 9534 into output shaft
bushing, thread Adapter J 26 19-4 and Slide Ham-
mer J
2619 into Bushing Tool and remove bush-
ing (Fig. 7G- 122).
3UTPUT RlNG GEAR
OUTPUT SHAFT
/
,,9534
Y
SLIDE HAMMER
+J 8 0 9 2
DRIVE H A N D L E
Fig. 7G-123 Installing Output Shaft Bushing
b. Install new bushing into front end of output shaft
by using Bushing Tool J 23062-7 and Drive Han-
dle J 8092.
c. Press in bushing .140" below end surface of shaft
(Fig. 7G- 123).
INTERMEDIATE CLUTCH
DIRECT CLUTCH ( I N N E R )
F O R W A R D CLUTCH
PUMP PRESSURE
I
TO RADIATOR
)
7
Fig. 7 6 - 1 2 2 Removing Output Shaft Bushing
Fig. 7 6 - 1 2 4 Front View of Case Oil Passages