Pontiac FIREBIRD 1972 Service Manual page 1092

76-54 1972 PONTIAC SERVICE MANUAL
DIRECT CLUTCH,
r
PUMP LIP SEAL DRAIN
FORWARD CLUTCH
( TO RADIATOR J
CONVERTER FEED
COOLER OUT
I
FROM RADIATOR
INTERMEDIATE
Fig. 7G-87 Pump Cover (Body Face) Oil Passages
2. Install new bushing into front end of stator shaft by
using Bushing Tool J 21424-7 and Drive Handle J
8092. Tap bushing into shaft to .250" below front face
of shaft (Fig. 76-89).
CAUTION:
Extreme care must be taken so
bushing is not driven past shoulder.
STATOR SHAFT REAR BUSHINGS
-
REPLACE
1. Remove front bushing as described above. Then,
thread Bushing Tool J 21424-7 into Extension J
21465- 13 and Drive Handle J 8092. Place tool assem-
bly through front of stator shaft and drive out center
and rear bushings.
\
J 2619-4
ADAPTER
PUMP COVER
AND STATOR
SHAFT ASSEMBLY
J 8 0 9 2
DRIVE
HANDLE
J 21424-7
/
PUMP COVER
A N D STATOR
SHAFT ASSEMBL
Fig. 76-89 Installing Shaft Front Bushing
2. Install new center bushing into hub end of pump
cover by using Bushing Tool J 23062-2, Extension J
2 1465-13, Drive Handle J 8092 and drive bushing to
approximately 1 1/32" below face of pump cover
hub. Then, install new rear bushing in same manner
flush to .010" below face of pump cover hub (Fig.
76-90).
ASSEMBLE
1. If oil pump body oil seal was removed, place pump
body on wood blocks and install new pump body-to-
converter hub liv oil seal. usina Seal Installer J 2 1359
to fully seat seai in its ckunte;bore (Fig. 7G-91).
EXTENSION
J 2 3 0 6 2 - 2
PUMP COVER
I
la
-?
A N D STATOR
4 1
Fig. 7G-88 Removing Shaft Front Bushing Fig. 7G-90 Installing Shaft Rear Bushings