Pontiac FIREBIRD 1972 Service Manual page 1112

7G-74 1972 PONTIAC SERVICE MANUAL
Fig. 7 G - 1 4 8 Compressing Low and Reverse Clutch Piston
NOTE: If clearance for installing snap ring is
not available, low and reverse clutch piston is
probably not aligned properly in case.
8. If output ring gear was separated from output shaft,
install ring gear to output shaft, retaining with a new
snap ring.
9. Install reaction carrier-to-output ring gear thrust
washer into output ring gear face (Fig. 70-149).
NOTE: Washer has three
(3)
narrow external
tangs.
10. Install output ring gear-to-case needle bearing onto
output shaft and install output shaft assembly into
case.
OUTPUT RING GEAR-
TANGED THRUST WASHER
Fig. 7 G - 1 4 9 Installing Output Ring Gear Thrust Washer
Fig. 7 G - 1 5 0 Installing Carrier onto Output Shaft
NOTE: Lip on inner race of needle bearing
faces rear of case.
11: Install reaction carrier assembly onto output shaft
assembly (Fig. 7G- 150).
12. Lubricate plates with transmission fluid and:
On V-8 models, install five (5) low and reverse clutch
faced plates and five (5) steel separator plates into
reaction carrier assembly, starting with a steel separa-
tor plate and alternating with faced plates (Fig. 7G-
15 1).
On 6 cylinder models, install four (4) faced and four
(4) separator plates into reaction carrier, starting
with a steel separator plate ( Fig. 7G-151).
Fig. 7 G - 1 5 1 Installing Low and Reverse Clutch Pack