Pontiac FIREBIRD 1972 Service Manual page 1362

12-92 1972 PONTIAC SERVICE MANUAL
l e f t from access
Start
Hole
in to the
lory
Fig. 12-102 Installing Ignition Switch (Tilt Column)
4. To replace, position shift tube in drive position.
5. Move gear selector out of reverse position to shear
pin.
ADJUST-MANUAL TRANSMISSION
1. Loosen switch retaining screws and move lever to
Reverse position.
2. Align hole in drive tang with slot in switch and insert
a .092 diameter pin.
3. Tighten screws and remove pin.
REMOVE AND REPLACE
-
AUTOMATIC
TRANSMISSION
-
CONSOLE SHIFT ONLY
1. Remove wire connector.
2. Remove retaining screws.
3. Remove switch.
5. Insert switch drive tang in shifter tube slot and as-
semble switch to steering column jacket with retain-
ing screws and adjust.
ADJUST
-
AUTOMATIC TRANSMISSION
-
CONSOLE SHIFT ONLY (FIG. 12-103)
All except X Series
1. Loosen switch retaining screws and move shift tube
to Park position.
2. Align hole with slot in back of switch and insert a
.092" diameter pin.
3. Tighten screws and remove pin.
4. Check starter operation in all ranges.
5. If starter operates in either reverse or drive, repeat
steps 1 through 4.