Data Port Configuration On The Meridian 1 Pbx - Nortel Remote Office 9150 Installation And Administration Manual

Hide thumbs Also See for Remote Office 9150:

Table of Contents

Sample configuration files

Data port configuration on the Meridian 1 PBX

Introduction

This section shows the configuration settings for the data port on the Meridian 1

PBX. The data port provides the communication path between the MIG RLC

and the Remote Office 9150 unit, and must be configured as an MCA adapter.

Configuration example

This configuration example uses the settings identified in the network diagram

shown on page 463.

Note: This configuration sample is from a Meridian 1 Option 11.

DES Remote site 1

CTD FBD WTD LPR MTD FND HTD ADD HFD

MWD LMPN RMMD SMWD AAD IMD XHD IRD NID OLD DTA DRG1

POD DSX VMD CMSD CCSD SWD LND CNDD

CFTD SFD MRD DDV CNID CDCA MSID DAPA BFED RCBD

ICDD CDMD LLCN MCTD CLBD AUTU

GPUD DPUD DNDD CFXD ARHD CLTD ASCD

CPFA CPTA ABDD CFHD FICD NAID BUZZ AHD

USMD USRD ULAD RTDD RBDD RBHD PGND FLXD FTTC DNDY DNO3

Telephone type

MIG RLC slot and port numbers

TGAR must be configured to allow

trunk access. Refer to your PBX

documentation for more details.

DTA defines the port as a data port.

Standard 1.0

Remote Office 9150