Overview - Nortel Remote Office 9150 Installation And Administration Manual

Configuring the Remote Office 9150 unit

Overview

Introduction
This chapter describes how to configure the Remote Office 9150 unit so that it
can route calls
over the IP and circuit-switched networks to or from the host PBX
to or from the local Public Switched Telephone Network (PSTN)
Configuring DSP modules
Each DSP application module that you add to your Remote Office 9150 unit
must be configured in Configuration Manager for it to increase your system's
call processing capabilities in the ways you intend. This configuration can only
take place after the modules have been installed.
IP addresses
To operate as a node on the IP network, the following items must be configured
on the Remote Office 9150 unit:
an IP address
a subnet mask
the default gateway
These items provide network connectivity between the MIG RLC on the host
PBX, the Remote Office 9150 unit in your office, and an administration PC.
With this connectivity in place, the following can occur:
Voice traffic can be routed between the MIG RLC and the Remote Office
9150 unit over the IP network.
You can use a PC that is located anywhere on the network to connect to and
administer the Remote Office 9150 unit (or MIG RLC).
Once connected, you can view or work with the system configuration.
Note: To do this, the Configuration Manager software must be installed on
that PC.
204
Standard 1.0
Remote Office 9150