Installation And Configuration; Contents; Introduction; Quick Reference To System Installation And Configuration - Nortel CS 1000M HG Manual

Installation and configuration

Contents

This section contains information on the following topics:
"Introduction" (page 39)
"Quick reference to system installation and configuration" (page 39)
"Installation overview" (page 41)
"Preinstallation preparation" (page 42)
"Fiber-optic equipment installation" (page 46)
"Remote IPE installation" (page 76)
"Configuring the equipment" (page 90)
"Configuring the Fiber Remote Multi-IPE Interface unit" (page 94)

Introduction

This section describes the installation of the Fiber Remote Multi-IPE
Interface unit as a part of a fiber-optic link connecting the local system to its
Remote IPE modules at distances of up to 15 kilometers. It explains how
to prepare the site and check the equipment before installing it and how to
configure it to the specific traffic requirements.
Quick reference to system installation and configuration
If familiar with the system operation and general system installation
practices, follow the steps below to speed up the installation of the Fiber
Remote Multi-IPE Interface and the Remote IPE:
1. Take inventory of the equipment by comparing the received equipment
Copyright © 2007, Nortel Networks
.
against the shipping documents. Refer to Table 2 in the Product
Description section for Remote IPE components part numbers and their
description.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
39