System Settings - Nortel Remote Office 9150 Installation And Administration Manual

March 2000

System settings

The node number and name are settings that uniquely identify each Remote
Office 9150 site in the telephone network.
The Remote Office 9150 unit obtains its time and date from the host PBX. If the
Remote Office 9150 unit is in a different time zone from the MIG RLC to which
it is connected, you can configure the time zone difference.
If your community has implemented an emergency number service (such as 911)
to call the police, fire department, or ambulance, and you are using the circuit-
switched network to route calls, you can configure the number on the Remote
Office 9150 unit. This allows users in your office to dial the emergency number
and be connected directly to the local emergency dispatch center without dialing
a trunk access code. The call can be made using either the host call appearance
or local call appearance keys.
You can enable paging on your Remote Office 9150 unit by doing the following:
Define a special prefix (SPRE) code for paging.
Enable the paging feature on each station that needs to use it.
Remote Office 9150 to MIG RLC connection information
Preventing toll fraud
You can implement a security authentication method on both the MIG RLC and
the Remote Office 9150 unit to prevent toll fraud.
The security level defines what type of security authentication is used between
the Remote Office 9150 unit and the host PBX. The information used to perform
security authentication depends on the security level chosen as follows:
no security
Caller ID
security ID
Connection information
Before you can establish a connection to the host PBX site, you must configure
the Remote Office 9150 unit to work with the MIG RLC. To accomplish this,
specify
Installation and Administration Guide
Configuring the Remote Office 9150 unit
205