Mig Rlc Configuration - Nortel Remote Office 9150 Installation And Administration Manual

Sample configuration files

MIG RLC configuration

Introduction
This section shows the configuration settings for the MIG RLC. You can obtain
a similar configuration printout by performing a configuration download while
connected to the MIG RLC.
Note: Configuration settings are separated by commas (,).
Configuration example
This configuration example uses the settings identified in the network diagram
shown on page 463.
IPCFG 10.2.1.1,255.255.0.0,10.2.1.10,10.3.1.2,255.255.0.0
APPMODCFG 0,NC,NC
APPMODCFG 1,E,G729,G729
APPMODCFG 2,NC,NC
APPMODCFG 3,NC,NC
APPMODCFG 4,NC,NC
APPMODCFG 5,NC,NC
APPMODCFG 6,NC,NC
APPMODCFG 7,NC,NC
SYSCFG 1,HOST1
RLCCFG E,E
ACCFG D
PORTCFG 0,1,0,2,2,D
PORTCFG 1,1,0,2,2,D
PORTCFG 2,1,0,2,2,D
PORTCFG 3,1,0,2,2,D
PORTCFG 4,1,0,2,2,D
PORTCFG 5,1,0,2,2,D
468
MIG RLC's IP address information:
IP address
Subnet mask
IP gateway
Management IP address
Management subnet mask
DSP application module
(only module 1 is configured
in this case)
Unit ID and node name
Ports configured as remote ports
Remote Office 9150
Standard 1.0