Overview - Nortel Remote Office 9150 Installation And Administration Manual

Configuring the Remote Office 9150 unit

Overview

Introduction
This section shows you how to configure your Remote Office 9150 unit to
connect with the MIG RLC on the host PBX.
RLC connection information
Before you can establish a connection to the host PBX, you must configure the
Remote Office 9150 unit to work with the MIG RLC. To accomplish this, you
must specify
the PSTN number used to connect to the host PBX, if you are using the
circuit-switched network to route calls
the IP address of the MIG RLC, if you are using the IP network to route
calls
whether you want to enable Block Incoming Local Call on Primary B
Channel
Security level
You can implement a security authentication method on both the MIG RLC and
the Remote Office 9150 unit to prevent toll fraud.
The security level defines what type of security authentication is used between
the Remote Office 9150 unit and the host PBX. The information used to perform
security authentication depends on the security level chosen as follows:
no security
calling line identification
Note: On the Remote Office 9150 unit, this is referred to as Caller ID.
security identifier
Note: On the Remote Office 9150 unit, this is referred to as Provision ID.
230
Standard 1.0
Remote Office 9150