Autel AutoLink AL419 Manual page 21

3) Press the OK button to save your selection and return to
previous menu.
Status Beep Set

The default setting is Beep On.
This function allows you to turn on/off the build-in speaker for the
LEDs in diagnostic testing. Different audio tone corresponds to
different LED lamp. This function is invaluable when working in
bright areas where LED illumination alone is not sufficient.
1) From System Setup screen, use the UP/DOWN scroll button to
select Status Beep Set and press the OK button.
2) From Status Beep Set menu, use the UP/DOWN scroll button to
select Beep ON or Beep OFF to turn on/off the beep.
3) Press the OK button to save your selection and return to previous
menu.
Tool Self-test
The Tool Self-test function checks if the display, LED lamps and
keyboard are working properly.
A. Display test
Status Beep Set
Beep ON

 Beep OFF
Figure 3.8
20
1/2
?