Obd Ii Monitor Readiness Status - Autel AutoLink AL419 Manual

operated under specific conditions before the monitor is ready. These
monitors are termed non-continuous monitors. For different ignition
type engines, the available monitors are different too.
The following monitors are to be used for spark ignition engines
only:
1) EGR System
2) O2 Sensors
3) Catalyst
4) Evaporative System
5) O2 Sensor Heater
6) Secondary air
7) Heated Catalyst
The following monitors are to be used for compression ignition
engines only:
1) EGR System
2) NMHC Catalyst
3) NOx aftertreatment
4) Boost pressure system
5) Exhaust gas sensor
6) PM filter

2.5 OBD II Monitor Readiness Status

OBD II systems must indicate whether or not the vehicle‟s PCM‟s
monitor system has completed testing on each component.
Components that have been tested will be reported as "Ready", or
"Complete", meaning they have been tested by the OBD II system.
The purpose of recording readiness status is to allow inspectors to
determine if the vehicle‟s OBD II system has tested all the
components and/or systems.
The power-train control module (PCM) sets a monitor to "Ready" or
"Complete" after an appropriate drive cycle has been performed. The
drive cycle that enables a monitor and sets readiness codes to "Ready"
varies for each individual monitor. Once a monitor is set as "Ready"
5