Testing, Power Up And Reset; Reset To Factory Defaults; Programming - Videx 4000 Series Technical Manual

TESTING, POWER UP AND RESET

After connecting the power supply, antenna, lock output and auxiliary devices as shown in
this manual and before powering up a SIM card must be installed. The SIM holder can be
found on the back of the module under the label 'SIM'. A SIM card from any supplier can
be used. Simply push the SIM card in (It will only fit one way). IMPORTANT: Replace the
label over the SIM hole.
- Check all the connections have been made correctly and then power up the system.
- The GSM intercom requires approximately 30 seconds too initialise properly. We
recommend not sending SMS messages or pressing buttons during this time.
- From power up; two short beeps will be heard and then following a short delay of
approximately 15 seconds, a further short beep will be heard. After approximately
another 15 seconds another short beep will be heard. The module is now fully
initialised (Note: If you here a different combination of beeps in place of the last short
single beep then you can find the meaning of these beeps towards the back of this
manual. Once initialised, you can begin programming.
Power up initialisation sequence
 2 short beeps
 Approx. 15 seconds delay
 1 short beep
 Approx. 15 seconds delay
 One short beep
 System is ready

RESET TO FACTORY DEFAULTS

There are two reset modes available. The first will reset the master code only and the
second will reset everything and clear all stored telephone numbers.
RESET THE MASTER CODE TO 1111
1. Power down the intercom panel
2. Put a short across terminals g & 7
3. Power up, 2 beeps will be heard followed by a delay and then a further beep.
4. Remove the short after the 3rd beep.
5. The master code is now reset to 1111
FULL RESET
1. Power down the intercom panel
2. Put a short across terminals g & 8
3. Power up, 2 beeps will be heard followed by a delay and then a further 2 beeps.
4. Remove the short after the 4
5. All settings are returned to factory defaults

PROGRAMMING

Programming can be carried out either by text message or by PC.
IMPORTANT NOTE: When you are required to use " in a text message it is very important to use the
correct symbol and not for example ' (Or two ' single apostrophes side by side which you will see
look the same but will be interoperated differently by the SMS intercom panel).
PAGE 16 of 40
th
beep.
GSM DOOR INTERCOM TECHNICAL MANUAL VER 2.0.8