Door Panel Mounting Frames; Power Supply - Videx 4000 Series Technical Manual

DOOR PANEL MOUNTING FRAMES

Both surface and flush mounting frames are available. The size of the frame will depend
on the number of modules that make up the door panel. The last digit of the frame code
indicates the number of modules it will take. Frames are available in gun metal gray finish,
chrome finish (Suffix \C to the frame code) or gold finish (Suffix \G to the frame code).
Flush frames:
Surface frames:

POWER SUPPLY

The GSM intercom panel is designed to work with power supplies in the range or 12-
14Vdc. The power supply should be capable of supplying a constant current of no less
than 1 amp (If the system is to work with failsafe lock releases or magnetic locks we would
recommend a minimum of 2 amps). The following Videx power supplies can be used:-
AMR2-12
Art.521B
SP29
SP28
ANTENNA
The GSM antenna connects to the SMA female bulkhead on the rear of the module. A
GSM antenna with a SMA male connector should be used.
Note: An antenna must always be connected.
Note: Always route the GSM cable away from the microphone wires and the power
supply wires to avoid interference on the speech channels.
PAGE 11 of 40
12-14Vdc 2A switched mode PSU
13.5Vdc 1A DIN box PSU
13.8Vdc 2A boxed PSU with battery back up facility
13.8Vdc 3A boxed PSU with battery back up facility
GSM DOOR INTERCOM TECHNICAL MANUAL VER 2.0.8