Set Ao (Auxiliary Output) Time (For Aom = 01 Only) (Aot); Set Ao (Auxiliary Output) Mode (Aom); Changing The Four Digit Code (Cde); Set Days To Wait Before Making A Call (Nod) - Videx 4000 Series Technical Manual

SET AO (AUXILIARY OUTPUT) TIME (FOR AOM = 01 ONLY) (AOT)

The AO time can be from 01 – 99 seconds or latching (Set the AO time to 00 for latched
mode). This option is only relevant for aux mode 01.
1111AOTnn
1111AOTnn?
1111AOT?

SET AO (AUXILIARY OUTPUT) MODE (AOM)

There are four modes of operation for the AO terminal:-
User activated: nn = 01
To activate the AO terminal either short g to 5 (Auxiliary 1 input) or press 6 on the
telephone during a call.
Call activated: nn = 00
AO will activate when a call begins and deactivate when the call ends.
Used for status indication: nn = 02
When in this mode, the AO terminal is used exclusively for monitoring the status of an
input. For example, checking if a gate/door is open of closed.
Divert calls to master number: nn = 03
When in this mode, the AO terminal is used exclusively for monitoring the status of a
switch to decide if calls should be divert to the master number or not.
1111AOMnn
1111AOMnn?
1111AOM?

CHANGING THE FOUR DIGIT CODE (CDE)

The four digit code can be any combination of numbers 0-9 but must be 4 digits long. The
code allows access to the programming menu in dial in mode and must be used when
sending text messages to the intercom panel. The following message changes the code:-
1111CDEnnnn

SET DAYS TO WAIT BEFORE MAKING A CALL (NOD)

In the event the intercom panel is not used for long periods of time it could be possible that
the network disconnects it. To prevent this from happening it is possible to program a time
period (From 01 – 99 days or disabled 00) to wait before the intercom panel makes a short
call to refresh the connection. This time period is reset after each call made on the system
and will only happen if the full time period elapses without any incoming or outgoing calls.
PAGE 20 of 40
Store the time nn = time in seconds.
Store the time nn = time in seconds. Also send a
confirmation text back to the sender.
Query the current stored time. A text message will be
sent to the sender showing the stored time.
Store the mode nn = 00 - 03.
Store the mode nn = 00 - 03. Also send a confirmation
text back to the sender.
Query the current stored mode. A text message will be
sent to the sender showing the stored mode.
nnnn = new 4 digit code
GSM DOOR INTERCOM TECHNICAL MANUAL VER 2.0.8