Storing The Call Button Telephone Numbers (Stn) (Std); Storing A Telephone Number For Dial In Door Release (Str) - Videx 4000 Series Technical Manual

OPTIONAL ?:
When sending text messages there may be a delay from when you send the message to when it is
received by the intercom panel depending on how congested the network is. If you are at the door
panel when sending the message you will here a single beep from the intercom panel to indicate it
has receive the message.

STORING THE CALL BUTTON TELEPHONE NUMBERS (STN) (STD)

Telephone numbers can be stored for the 50 available call buttons. Each call button can
call up to two telephone numbers (If the first is busy or not answered in a certain time it
can call the second number if the divert facility is setup). The STN code stores the first
number called when the button is pressed and the STD code stores the diverted telephone
number if the first is busy or not answered. The messages to store/check numbers are as
follows (Replace STN with STD when storing/checking divert numbers).
1111STNnnn"yyyyyyyyyyy"
1111STNnnn"yyyyyyyyyyy"?
1111STNnnn?
1111STNnnn""
1111STNnnn""?
nnn is a button number between 001 & 050. The telephone number y can be a maximum
of 30 digits.
Example: To store the number 01912243174 for button 5 and a divert number if that one is
not answered or busy of 01912241558 would be the following two SMS messages:-

STORING A TELEPHONE NUMBER FOR DIAL IN DOOR RELEASE (STR)

Dial in door release allows users of telephones with their number stored to release the
door/gate simply by dialling the telephone number of the SIM in the intercom panel. The
intercom panel will check the callers ID when it receives a call and if it matches the list of
stored numbers, it will clear the call down (Avoiding the caller being charged for the call)
and will activate the relay for the programmed time. Up to 250 numbers can be stored. The
messages to check, store or delete numbers are as follows.
1111STRnnn"yyyyyyyyyyy"
PAGE 18 of 40
Most of the commands support the ? feature. When this is added to the end of the
text message, a confirmation text message will be sent back to the sender indicating
the new data has been received and stored.
Store the primary telephone number yyyyyyyyyyy in
position nnn
Store the telephone number yyyyyyyyyyy in position nnn
and send a confirmation text message to confirm
storage of new number.
Query the telephone number stored in location nnn. A
text message will be sent to the sender with the stored
number for that location.
Delete the telephone number stored in location nnn.
Delete the telephone number stored in location nnn. A
text message will be sent to the sender with the delete
confirmation for that location.
1111STN005"01912243174"
1111STD005"01912241558"
Store the telephone number yyyyyyyyyyy in position nnn
where nnn = 001 - 250
GSM DOOR INTERCOM TECHNICAL MANUAL VER 2.0.8