Set Call Time (Spt); Set Relay Time (Rlt) - Videx 4000 Series Technical Manual

1111STRnnn"yyyyyyyyyyy"?
1111STRnnn?
1111STRnnn""
1111STRnnn""?
Note: It is important to switch off voicemail and automatic SMS features on the SIM card when using
this feature. See the 'Forced Dial' section for more details. Also note that it will not be possible to use
the dial in to speak facility from a number stored to release the door/gate when dialling in (Door
release takes priority).

SET CALL TIME (SPT)

The call time is the maximum time in seconds that a call can last before the intercom panel
automatically clears the call down. The time can be from 20 seconds up to 240 seconds (4
minutes) and begins from when the call button is pressed. The default time is 40 seconds.
The following messages are used to set/check the maximum call time.
1111SPTnn
1111SPTnn?
1111SPT?

SET RELAY TIME (RLT)

The relay time can be from 01 – 99 seconds or latching (Set the relay time to 00 for
latched mode. In latch mode, the relay will stay energised until the command is send
again).
1111RLTnn
1111RLTnn?
1111RLT?
PAGE 19 of 40
Store the telephone number yyyyyyyyyyy in position nnn
where nnn = 001 - 250and send a confirmation text
message to confirm storage of new number.
Query the telephone number stored in location nnn
where nnn = 001 - 250. A text message will be sent to
the sender with the stored number for that location.
Delete the telephone number stored in location nnn
where nnn = 001 - 250.
Delete and confirm deletion of a telephone number in
location nnn where nnn = 001 - 250.
Store the time nn x 20 seconds (e.g. nn = 03, time = 60
seconds.
Store the time nn x 20 seconds (e.g. nn = 02, time = 40
seconds. Also send a confirmation text back to the
sender.
Query the current stored time. A text message will be
sent to the sender showing the stored time. (Remember
to multiple the number in the received text by 20
seconds)
Store the time nn = time in seconds.
Store the time nn = time in seconds. Also send a
confirmation text back to the sender.
Query the current stored time. A text message will be
sent to the sender showing the stored time.
GSM DOOR INTERCOM TECHNICAL MANUAL VER 2.0.8