Table of Contents
Advertisement
Installation and Testing
To test the module
To test the module
The logic analyzer module does not require calibration or adjustment. After
installing the module, you can test and use the module.
•
If you require a test to initially accept the operation, perform the
self-tests in the next section.
•
If you require a test to verify the specifications, you must obtain the
optional Service Guide from your HP Sales Office. Start at the
beginning of chapter 3, "Testing Performance."
•
If the module does not operate correctly, use the optional Service
Guide and go to the beginning of chapter 5, "Troubleshooting."
To perform the self-tests
The self-tests verify the correct operation of the logic analyzer module.
Self-tests can be performed all at once or one at a time. When testing the
performance of the module, run the self-test all at once.
Disconnect all inputs, then turn on the power switch.
1
In the System Configuration menu, touch Configuration. In the
2
pop-up, touch Test.
Touch the box labeled Touch box to Load Test System.
3
13–10
Advertisement
Table of Contents
