Canon ipf8300 User Manual page 931

ManageRemainRoll
Paper Details
iPF8300
Downloaded from ManualsPrinter.com Manuals
Setting Item
(The type of pa- Head Height
per is displayed
here.)
Skew Check
( *1 )
→P.914
Lv.
Cutting Mode
Cut Speed
Trim Edge
First
CutDustRe-
duct.
Vac-
uumStrngth
Scan Wait
Time
Roll Drying-
Time
NearEnd
RollMrgn
Description, Instructions
Choose On to print a barcode at the end of a roll before you
remove it. The printed barcode can be used in managing the
amount of roll paper left. Choose Off if you prefer not to
print the barcode.
(See "Keeping Track of the Amount of Roll Paper Left.")
→P.791
Adjust the Printhead height. (See "Troubleshooting Paper
Abrasion and Blurry Images (Head Height).")
If you print on Japanese paper (washi) or other handmade
paper that has an irregular width, choose Loose for a higher
skew detection threshold, or choose Off to disable skew de-
tection. However, if paper is loaded askew when detection is
Off, note that paper jams or Platen soiling may occur.
Specify whether or not to cut with the standard round-bladed
cutter.
If you choose Automatic, the roll will be cut automatically
using the Cutter Unit, depending on the printer driver set-
tings. If you choose Manual, the paper will not be cut after
printing. Instead, a line will be printed at the cut position.
Choose Eject if you prefer not to have documents dropped
immediately after printing, as when waiting for ink to dry.
Choose the cutting speed. The preset selection represents the
optimal cutting speed for the type of paper. We recommend
keeping the preset cutting speed.
If you use adhesive paper, choosing Slow helps prevent ad-
hesive from sticking to the cutter and keeps the cutter sharp.
If a roll is loaded, the end of the paper will be cut.
If you choose On, a line will be printed at the cut position
when paper cutting is selected. This option reduces the
amount of debris given off after cutting. It also helps prevent
adhesive from sticking to the cutter and keeps the cutter
sharp if you use adhesive paper. (See "Reducing Dust from
Cutting Rolls.")
→P.801
Specify the level of suction that holds paper against the Plat-
en. (See "Adjusting the Vacuum Strength (Vac-
uumStrngth).")
→P.852
Specify the time to wait for the ink to dry between each scan
in bidirectional printing, in consideration of how quickly the
ink dries. Note that printing will take longer if you specify a
wait time.
Specify the time to wait for the ink to dry for each sheet.
Specify the minimum margin at the leading edge of roll pa-
per to ensure better printing quality at the leading edge.
Note that if you choose 5mm, it may lower the printing
quality at the leading edge and affect feeding accuracy. The
printed surface may be scratched, and ink may adhere to the
leading edge. It may also cause the Platen to become soiled.
Printer Parts > Control Panel
→P.843
Menu Settings
>
9
913