Rudder Pushrod Installation - Seagull Models YAKOVLEV YAK 3 ARF Assembly Manual

YAK 3
3) Thread one clevis and M2 lock nut on
to each elevator control rod. Thread the
horns on until they are flush with the
ends of the control rods.
4) Elevator and rudder pushrods assem-
bly as pictures below.
M2 clevis.
Fuel tubing.
8mm
26
Elevator pushrod.
Hex nut.
Pen.
M2 lock nut. M2 clevis.
Instruction Manual.
8mm
RUDDER PUSHROD
INSTALLATION.
Repeat steps as same as steps done for
elevator.
M2 lock nut.
8mm
Nylon Snap Keeper.
M2 clevis.