Table of Contents
Advertisement
YAK 3
Instruction Manual.
INSTALLING VERTICAL STABILIZER
INSTALL RUDDER CONTROL HORN.
1) Using a modeling knife, remove the
Repeat steps to install the rudder con-
covering from over the precut hinge slot
trol horn as same as steps done for ailer-
cut into the lower rear portion of the fu-
selage. This slot accepts the lower rudder
hinge.
Fiberglass control horn
Remove covering.
Epoxy.
Fill Epoxy
2) Slide the vertical stabilizer into the slot in
the top of the fuselage. The rear edge of the
stabilizer should be flush with the rear edge
of the fuselage and the lower rudder hinge
should engage the precut hinge slot in the
lower fuselage. The bottom edge of the stabi-
lizer should also be firmly pushed against the
top of the horizontal stabilizer.
Rudder fiberglass control horn.
24
Advertisement
Table of Contents
