OSEE XCM-250-OLED User Manual page 73

Default
Items
Value
IMD ID 0
IMD NAME XXXXXXXX
BAUD RATE 38400
LED TALLY ON
OSD TALLY
RG
MODE
IMD TALLY
T1
MODE
TALLY
STANDARD
SOURCE
OSD TALLY MODE
1.
The OSD TALLY MODE is available, only when setting IMD
MenuTALLY SOURCE as Standard. Set GPI1 as TALLY GREEN and
GPI2 as TALLY RED in GPI menu, the status of OSD TALLY and LED
TALLY when the Tally connector gets the high/low level are listed as
shown in Table 5.1-18:
Table 5.1-18 The status of OSD TALLY and LED TALLY When Triggering
OSD
Green
TALLY
TALLY
MODE
OFF 0/1
Domain Range
0~255
2400/4800/9600/19200
/38400/57600/115200
OFF/ON
 RG: Red/Green
 GR: Green only
 RGY:
Red/Green/Yellow
OFF: No tally light

T1/T2/T1T2/T2T1/T1-/
T2-/T1T2-/T2T1-
STANDARD/IMAGE
VIDEO/TSL
the Tally Pins
Red
Illustration
TALLY
0/1
Functionality of the Main Menu
Description
Set the ID number for
each monitor
Set an IMD name for
each screen.
Select a baud rate for
communication.
Set whether to switch on
tally light.
Select the OSD Tally
mode. Only the TALLY
SOURCE is STANDARD
or STANDARD + IV422,
the setting is available.
Select the IMD Tally
mode.
Use this setting when
using the Image Video
tally control, this setting
will determine the state
which is selected.
Select the source for
LED tally source
67
LED
TALLY