OSEE XCM-250-OLED User Manual page 60

Functionality of the Main Menu
The input signal information of the main picture displays at the top left
corner of the screen, and the one of the slave picture displays at the top
right corner of the screen.
 Set the signal source for the main picture: press INPUT key on the
front panel to display the SOURCE list, select an input signal source as
the main source.
 Set the signal source for the slave picture: press MENU key on the
front panel to display the OSD menu list, and select the menu item
CONFIG SUB IN SELECT to set an input signal source as the slave
source.
 Select input source format for LINE2: For the LINE2(CVBS) interface, the
LINE2(Y/C) interface and the LINE2(YPSPR) interface share the same
group of physical interfaces, select the signal source format for LINE2
according to the line connection mode. When select a signal source format
for LINE2, you can set the menu item INPUT SELECTLINE2 as CVBS,
LINE2(Y/C) or LINE2(YPBPR), in addition, press INPUT button to pop up
the source list for LINE2 selection.
Set SDI ASSIST MODE
2.
 Interlace Mode
Interlace Display mode offers faithful reproduction of the input signal, the
picture is displayed in interlace mode by inserting the black line without I/P
conversion processing. The picture near the original quality of the input
signal is monitored.
Select the menu item CONFIG SDI ASSIST MODEN to be set to
ITERLACE MODE, thus to display these inputs as a true interlace display.
The display result in the INTERLACE MODE is as shown in Figure 5.1-29:
OFF
Figure 5.1-29 Interlace Mode
54
INTERLACE