OSEE XCM-250-OLED User Manual page 18

Unpack and Installation
Fasten the power protect accessory.
6.
As a final step, turn on the power switch on the rear panel to power
7.
on the device, and press POWER button located on the front panel
to start up the screen.
 The pedestal and the monitor are packaged separately.
 Connect a standard signal lines to the corresponding input port. All BNC
connector impedance must be 75Ω.
 Please use the power adapter supplied to avoid unnecessary trouble.
 Use the power adapter and cord to connect single-phase three-wire AC
power or following the local power supply conditions. Make sure the power
cord grounding well.
 The factory default value for IP address is 192.168.1.86.
.
12