Installation; Connecting To The Pc Via Lan; Connecting The Milling Unit To The Power Supply; Installing The Unit - Sirona CEREC MC XL Operating Instructions Manual

5 Installation and startup
5.4 Initial startup
20
5.4.7

Installation

5.4.7.1

Connecting to the PC via LAN

An Ethernet connection is located to the rear of the unit, which can be
used to connect the PC to the milling unit. Use a network cable to do this
(LAN connection).
Using a network cable
Connect the PC to the LAN connection of the unit.
If problems arise when connecting via a network cable, please read the
separate instructions "Operating the MC XL via LAN".
5.4.7.2

Connecting the milling unit to the power supply

NOTICE
Grounded power outlet
The milling unit must be connected to a grounded power outlet.
➢ Connect the milling unit to the power supply with the power cable
included in delivery.
5.4.7.3

Installing the unit

You must connect the unit to the PC before putting it into operation. This
Introduction worldwide
is described in the section entitled "Connecting to the PC via LAN" [ → 20]
or "Connecting to the PC via WLAN (option)" [ → 23].
Searching for a title automatically
Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL Premium Package
D 3439.201.06.03.02 04.2014
63 98 536 D 3439