Master Programming Level; 1=Autoprogram - Fire-Lite MS-9600LS Manual

Master Programming Level

To enter the user Programming mode, press 2. The display will read as follows:
Entering the Master level password (default 00000) will cause the following screen to appear:
If the Maintenance level password (default 11111) is entered, the following screen will appear:
Note that in the two preceding screens, an arrow appears to inform the programmer that additional
options can be viewed by pressing the keypad down arrow key.
3.6 Master Programming Level
When the Master Program Level password is entered, the control panel will enter user Program-
ming mode. In this mode, the piezo sounder remains off, the trouble relay is activated and the sys-
tem Trouble LED flashes until Programming mode is exited. The following display will appear:
The down arrow which appears in the display indicates that additional programming choices can be
viewed by pressing the down arrow key on the keypad. If a down and up arrow appear in the dis-
play, pressing the 'down' arrow key will display the subsequent Programming Screens as illustrated
below while pressing the 'up' arrow key will display the previous screen.
1=LOOP SETUP
2=SYSTEM SETUP
3=VERIFY LOOPS
3.6.1 Autoprogram
PROGRAMMING
Pressing 1 while viewing Programming Screen #1, will select the Autoprogram option, which

1=AUTOPROGRAM

2=POINT PROGRAM
prompts the control panel to poll all devices installed on one or both SLC loops. The primary pur-
3=ZONE SETUP
pose of autoprogramming is to allow the installer a fast and easy way to bring the system on-line as
Programming Screen #1
quickly as possible. The first time the system is powered-up, it should be autoprogrammed.
If the system is already programmed and Autoprogram is initiated, the system will only add default
values for newly installed devices.
MS-9600LS Series Manual — P/N 52646:B8 11/20/2015
PROGRAMMING
Programming Screen #2
PROGRAMMING
ENTER PASSWORD

PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
PROGRAMMING
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #1
PROGRAMMING
1=HISTORY
2=WALKTEST
3=OPTION MODULES
Programming Screen #3
Programming
PROGRAMMING
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=PROGRAM CHECK
Programming Screen #4
67