Ricoh Aficio 480W Dolphin-C2 Service Manual page 51

28 April 2005
[E]
[F]
[A]
[G]
23. Install the harness clamp [A] and connect the cables [B], [C], [D], and [E].
NOTE: Be sure to clamp cable [C, E] as shown with the pre-installed clamp [F].
24. Secure the ground (earth) wire [G] (1 screw M4x6 with spring washer).
25. Reinstall the lower front cover [H] and attach the decal [I] (2 hex. tapping
screws M4x8 with flat washer).
26. Reinstall the power supply unit, toner collection bottle, and covers.
NOTE: Connect the "N" (Neutral) connector on the left and connect the "L"
(Line) connector on the right.
!
CAUTION
When you position the power supply unit for re-installation, make sure that
the flat ribbon cable is not pinched at the top right.
[B]
[I]
[H]
1-29
ROLL FEEDER (B758)
[D]
[C]
[A]
B758I111.WMF
B010I517.WMF