Table of Contents
Advertisement
SPECIAL PROCEDURES WITH SD CARDS
Downloading NVRAM Data from an SD Card
Important
• Downloading NVRAM data from an SD card may fail if the SD card is defective
or if there is poor connection between the controller and the BCU.
• If downloading NVRAM data from an SD card fails, just repeat the procedure.
• If the second attempt to download from the SD card fails, then you must enter
the SP and UP settings manually from the SMC report your printed before
uploading the NVRAM data to the SD card.
To download data from an SD card to NVRAM
1. Turn the machine off.
2. Insert the SD card to hold the NVRAM data in Slot 1 (the top slot).
3. Turn the machine on.
4. Enter the SP mode and do SP5825.
The download executes, provided the SD card contains the NVRAM data for
the machine. (The machine serial number in the file name of the NVRAM data
must match the registered number of the machine.)
-or-
The download will not proceed if the correct NVRAM data is not on the SD card.
5-4
28 April 2005
Advertisement
Table of Contents
Troubleshooting
