After Replacement; To Download Nvram Data From The Sd Card - Ricoh Aficio 480W Dolphin-C2 Service Manual

BOARDS

After Replacement

1. Turn the machine main power on.
2. Do SP5801 001 (All Clear) to reset all of the NVRAM memory to the defaults.
3. Make sure that the counter is zero (see the User Tools main menu).
4. Input the serial number with SP5811 001 (contact the technical supervisor).
NOTE: The machine serial number must be re-entered manually.

To Download NVRAM Data from the SD Card

1. Turn the machine off.
2. Insert the SD card to hold the NVRAM data in Slot 1 (the top slot).
3. Turn the machine on.
4. Enter the SP mode and do SP5825.
5. Print an SMC report with SP5990 002.
6. Compare the information in this SMC report with the one you printed before
NVRAM removal.
• If the content of the SMC reports do not match, this means that the content of
the old NVRAM could not be uploaded to the SD card.
• In this case, do SP5801 001 again and do the settings recommended for the
machine.
Important: The recommended settings are printed on a sheet of paper taped
on the inside of the rear cover.
3-60
28 April 2005