Installing And Removing Mscs, Plims, And Associated Components; Information About Installing And Removing Cards And Associated Components - Cisco ASR 14000 Series Installation Manual

Installing and Removing MSCs, PLIMs, and
Associated Components
This chapter provides instructions on how to install and remove the Cisco ASR (Aggregation Services
Router) 14000 series 8-slot line card chassis modular services cards (MSCs), physical layer interface
modules (PLIMs), and any associated components. This chapter presents the following topics:
•
•
•
•
•
•
•
•
•
•
Information About Installing and Removing Cards and
Associated Components
This section contains some general information about installing and removing cards, PLIMs, and
associated components.
•
•
•
•
•
•
OL-16973-01

Information About Installing and Removing Cards and Associated Components

How to Install or Remove a Slot Cover
How to Install or Remove an Impedance Carrier
How to Install or Remove a Pillow Block
How to Install or Remove a Switch Fabric Card
How to Install or Remove an MSC
How to Install or Remove an RP Card or DRP PLIM
How to Install or Remove a PCMCIA Card
How to Install or Remove a Physical Layer Interface Module (PLIM)
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Guidelines and Warnings for Card Installation and Removal
Information About Impedance Carriers and Slot Covers
Information About Distributed Route Processors and Distributed Route Processor PLIMs
Information About Small Form-Factor Pluggable (SFP) Modules
Information About Hard Drives and PCMCIA Cards
Information About Cable Management Brackets
C H A P T E R
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4
4-1