Networkservices Ssh Allowpublickey; Networkservices Ssh Mode; Networkservices Telnet Mode; Networkservices Upnp Mode - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

NetworkServices SSH Mode

SSH (or Secure Shell) protocol can provide secure encrypted communication between the
codec and your local computer.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH protocol is disabled.
On: The SSH protocol is enabled.

NetworkServices SSH AllowPublicKey

Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.

NetworkServices Telnet Mode

Telnet is a network protocol used on the Internet or Local Area Network (LAN) connections.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The Telnet protocol is disabled. This is the factory setting.
On: The Telnet protocol is enabled.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals Maintenance

NetworkServices UPnP Mode

Fully disable UPnP (Universal Plug and Play), or enable UPnP for a short time period after
the video system has been switched on or restarted.
The default operation is that UPnP is enabled when you switch on or restart the video
system. Then UPnP is automatically disabled after the timeout period that is defined in the
NetworkServices UPnP Timeout setting.
When UPnP is enabled, the video system advertises its presence on the network. The
advertisement permits a Touch controller to discover video systems automatically, and
you do not need to manually enter the video system's IP address in order to pair the Touch
controller.
Requires user role: ADMIN
Default value: On
Value space: <Off/On>
Off: UPnP is disabled. The video system does not advertise its presence, and you have
to enter the video system's IP address manually in order to pair a Touch controller to the
video system.
On: UPnP is enabled. The video system advertises its presence until the timeout period
expires.

NetworkServices UPnP Timeout

Define for how many seconds UPnP shall stay enabled after the video system is switched
on or restarted. The NetworkServices UPnP Mode setting must be On for this setting to
take any effect.
Requires user role: ADMIN
Default value: 600
Value space: <0..3600>
Range: Select a value between 0 and 3600 seconds.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
103
Administrator Guide
System settings System settings Appendices