Connecting Power Supply Leads And Start-Up - Ever Power Systems POWERLINE RT-6000 Instruction Manual

Table of Contents

Advertisement

EVER UPS POWERLINE RT 6000 / 10000 series instruction manual

CONNECTING POWER SUPPLY LEADS AND START-UP

The UPS unit should be connected to the mains and to receivers using cables with
relevant profiles. Installation recommendations are available in a separate document,
included to the product.
CAUTION! Using cables with profiles smaller than the minimal profiles
required, may cause the following: cables burn, interruption in electrical
connections and even a fire.
CAUTION! Connecting the UPS unit may be carried out only by suitably
qualified service technicians, with professional licences required by law.
CAUTION! Always connect the grounding conductor first.
The UPS unit is not equipped with an automatic device securing it from the back
feed, therefore it is recommended to install an external separating device shown in
the below figure. Before running the circuit ensure no dangerous voltage occurs
between terminals.
2017-01-05 13:16
Technical Support, tel.: +48 61 6500 400
30
www.ever.eu

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POWERLINE RT-6000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Powerline rt-10000

Table of Contents