JUKI SC-922 Engineer's Manual page 47

™ ™ ™ ™ ™
Function of limiting alternate vertical speed (Function setting Nos. 162 and 163)
Maximum speed is limited in accordance with the alternate vertical moving amount.
Speed is limited by a lower speed limit resulting from comparing with a speed limit that is specific to a machine
head.
Refer to the instruction manual of the machine head to be used for the machine-head-specific speed limit.
1 6 2 d L
d L S E n
d L
S P
d L 1
d L 2
S P d 1 1
S P d 2 3 5
S P d 1 1
S P d 4 3 5
Setting examples (for LU-2200VR type machine head)
The speed is set to 3500 sti/min for alternate vertical moving amount 3, and the speed is set to 1500 sti/min
for alternate vertical moving amount 5.
1 6 2 d L
d L
d L S
d L 1
d L 1
d L 2
d L 2
d L S d L
d L S S P d
S P d 1 1 5
S P d 1 3 5
S P d 2 1 5
A
B
S
Select function No. 162 for operation methods of function settings 1 to 3.
d
Use the key
d
[When "dL" is selected] (only for LU-2200VR type machine head)
2
Use the key
"dL1" appears on the indicator A. Use the key
6
vertical moving amount.
[When "SPd" is selected] (for LU-2200VR type machine head)
5 0
Use the key
the indicator A. Use the key
0 0
[When "SPd" is selected] (for the heads other than the above )
5 0
Use the key
the indicator A. Use the key
0 0
S
1. Select function No. 162 for operation methods of function settings 1 to 3.
2. Use the key
2
3. Use the key
3
4. Use the key
2
5. Use the key
5
6. Use the key
7. Use the key
8. Use the key
0
9. Use the key
0 0
10. Use the key
0
11. Use the key
or to select "_End", "dL_ _", or "SPd_".
or to select the alternate vertical moving amount, 1 or 2, after
or to select the setting speed, 1 or 2, after "Spd1" appears on
or to specify the speed to be set.
or to select the setting speed, 1 to 4, after "Spd1" appears on
or to specify the speed to be set.
or to select the "dL" item.
to select "dL1".
or to set the value of dL1 to "3".
to determine the set value and select "dL2".
or to set the value of dL2 to "5".
to determine the set value.
or to select the "SPd" item.
to select "SPd1".
or to set the value of SPd1 to "3500".
to determine the set value and select "SPd2".
– 43 –
or to enter the alternate