JUKI SC-922 Engineer's Manual page 33

(Start level ; U : User's mode, S : Service mode)
No. Item
154 Function of Enabled in combination with a machine head
shortened equipped with the function of shortened stitching for
stitching at trimming remaining short thread
start/end Shortened stitching is performed at start and end.
(shortened stitching performed instead of automatic
reverse feed stitching)
0 : Function disabled
1 : Function enabled
155 Setting of neutral No. 21 : The setting of neutral automatic presser
automatic lifting shall be enabled only at the down position.
presser lifting 0 : Neutral automatic presser lifting always enabled
1 : Neutral automatic presser lifting enabled only
(No. 93 When the setting value of the function of
adding the needle up/down compensating switch
is "2" the setting is disabled.)
156 Needle thread Enabled in combination with a machine head
clamp function equipped with the needle thread clamp function
Selection of needle thread clamp switch function
0 : Toggles ON and OFF with the operation
1 : Needle thread clamp disabled
2 : Forcibly enabled
157 Thread clamp Enabled in combination with a machine head
function during equipped with the needle thread clamp function
thread trimming Function of thread clamping when the thread is
being trimmed
0 : Function disabled
1 : Function enabled
158 Shortened Enabled in combination with a machine head equipped
stitching with the function of shortened stitching for trimming
function during remaining short thread
thread trimming The shortened stitching output for trimming remaining
short thread during control of thread trimming can
be set to present or absent.
0 : Function disabled
1 : Function enabled
159 Function of lifting The presser can be lifted before reverse rotation to
presser to up lift the needle after thread trimming.
position at reverse 0 : Function disabled
revolution after 1 : Function enabled
thread trimming
160 Thread trimming The parameters related to thread trimming can be
setting specified in detail.
161 Setting of Function settings are added to one-touch setting
one-touch operations.
operations
162 Setting of Maximum speed limited depending on the alternate
speed limited vertical moving amount can be specified.
by alternate
vertical moving
amount
163 Function of Maximum speed is limited in accordance with the
limiting alternate alternate vertical moving amount.
vertical speed 0 : Disabled
164 High-speed High-speed operation is always performed when an
switching input is provided from the standing pedal.
function by 0 : Function disabled (input from standing pedal
standing pedal
input 1 : Function enabled (high-speed operation)
165 Selection of The thread trimming switch function is toggled.
thread trimming 0 : Switch of normal thread trimming
switch function 1 : Switch of presser lifting after thread trimmin
∗
Do not change the set values with asterisk (
of delivery is changed, it is in danger of causing the machine to be broken or the performance to be deteriorated.
Description
at down side stop
enabled switch
usually)
∗
) mark as they are functions for maintenance. If the standard set value set at the time
Setting range Setting level
0/1
0/1
0 to 2
0/1
0/1
0/1
—
—
—
0/1
0/1
0/1
– 29 –
Indication of
function setting
U
1 5 4
U
1 5 5
U
1 5 6
S
1 5 7
U
1 5 8
S
1 5 9
S
1 6 0 T r M
S
1 6 1
S E T
S
1 6 2 d L S
U
1 6 3
U
1 6 4
S
1 6 5
Ref.
page
42
0
35
0
42
0
0
0
42
0
42
42
43
44
0
0
0