JUKI SC-922 Engineer's Manual page 44

i i i i i
Function added to the needle up/down compensating switch (Function setting No.93)
One stitch operation can be performed only when the needle up / down compensating switch is pressed at the
time of upper stop immediately after turning ON the power switch or upper stop immediately after thread trim-
ming.
9 3
o o o o o
Continuous stitching + one shot stitching nonstop function (Function setting No. 94)
This function is used to proceed a step to the next one without stopping the sewing machine at the end of the
step when performing sewing with the continuous sewing and one-shot sewing combined using the program-
ming function of the operation panel IP.
9 4
p p p p p
Setting of max. number of rotation of the sewing machine head (Function setting No. 96)
This function can set the max. number of rotation of the sewing machine head you desire to use.
Upper limit of the set value varies in accordance with the sewing machine head to be connected.
9 6 3 0
a a a a a
Reversing brake start angle (Function setting No. 107)
Brake start angle of function of reverse revolution to lift needle after thread trimming can be set. Set value
determines the angle from the end of up position detection.
1 0 7
As to angle: It indicates the angle of normal rotation from OFF signal of up position detection when the sewing
machine rotates in the normal direction.
s s s s s
Main shaft reference angle compensation (Function setting No. 120)
Main shaft reference angle is compensated
1 2 0
d d d d d
UP position starting angle compensation (Function setting No. 121)
Angle to detect UP position starting is compensated.
1 2 1
f f f f f
DOWN position starting angle compensation (Function setting No. 122)
Angle to detect DOWN position starting is compensated.
1 2 2
g g g g g
Setting of energy saving function during standby (Function setting No.124)
It is possible to reduce power consumption while the sewing machine is in standby state. It should be noted that
the startup of the sewing machine may delay for a moment if this function is set.
1 2 4
h h h h h
Setting of accessory devices (Function setting No. 141)
Accessory devices to be mounted on the machine head are selected.
1 4 1 F U
Settings of the devices to be mounted as standard are automatically performed. Refer to "10. Thread trimming •
Setting of accessory devices (2)" for further information on settings.
0 : Normal (Only needle up / down compensating stitching operation)
1 : One stitch compensating stitching operation (upper stop → upper stop) is
0
performed only when aforementioned changeover is made.
2 : Needle-down function operates after thread trimming.
3 : Function of needle-down with operation of "2:" plus presser lowering opera-
tion and needle-up with thread trimming operation is added.
0 : Normal (Stop when a step has completed.)
0
1 : The sewing machine proceeds to next step without stopping after a step has
completed.
150 to Max. [sti/min] <50 sti/min>
0 0
0 : Invalid (Brake function starts from the end of up position detection.)
0
Setting range : 1 to 359 <1°>
1 to 359: After rotating, brake works in the range of set angle.
Setting range : –60 to 60° <1°>
0
Setting range : –15 to 15° <1°>
0
Setting range : –15 to 15° <1°>
0
0 : Energy-saving mode is ineffective.
0
1 : Energy-saving mode is effective.
n
– 40 –