JUKI SC-922 Engineer's Manual page 46

n n n n n
Tie stitch adjustment function (Function setting Nos. 151, 152, and 153)
Sewing temporarily stops at sewing start and end, and at each corner of overlapped stitching if reverse feed
stitching and overlapped stitching are active.
(Caution) If this function is set to ON, the function setting Nos. 51 to 53 are disabled.
Function setting No. 151
1 5 1
Function setting No. 152
1 5 2
Function setting No. 153
1 5 3
m m m m m
Shortened stitching function at sewing start and end (Function setting No. 154)
Shortened stitching is performed instead of automatic reverse feed stitching with use of the machine head
equipped with the shortened stitching mechanism.
Use this function when you would like to prevent unthreading at sewing start and end without using the reverse
feed stitching function.
1 5 4
, , , , ,
Needle thread clamp function (Function setting No. 156)
The needle thread clamp function is set to enabled or disabled.
1 5 6
. . . . .
Function of lifting presser to up position at reverse revolution after thread trimming (Function setting No. 159)
The timing of automatic presser lifting at needle lifting in a reverse rotation after thread trimming is advanced.
Enabled this function allows lifting the presser at the up position after thread trimming and lifting the needle in a
reverse rotation.
When the function is disabled, the presser is lifted after needle lifting in a reverse rotation.
1 5 9
(Caution) The function is always disabled if a wiper-equipped machine head is used.
/ / / / /
Thread trimming setting (Function setting No. 160)
Part of operation timing of machine-head-specific thread trimming can be adjusted.
1 6 0 T r
Refer to "10. Thread trimming • setting of accessory devices (1)" for further information on settable items and
how to set.
¡ ¡ ¡ ¡ ¡
Setting of one-touch operations (Function setting No. 161)
Items settable with one-touch operation are added.
1 6 1 S E
Refer to "12. Setting of one-touch operations" for further information on settable items and how to set.
The function is set to enabled or disabled.
0 : Function OFF
0
1 : Function ON
The stop period is specified.
0 to 1000ms
0
The brake angle to stop sewing is specified.
0 to 180 degrees (from the beginning of down detection)
0
Sewing temporarily stops at this position.
0 : Function OFF
0
1 : Function ON
0 : Toggles between enabled and disabled with the operation enabled switch.
1 : Function disabled
0
2 : Function enabled
0 : Function disabled
0
1 : Function enabled
M
T
– 42 –