Wiring Information - Furuno BR-500 Operator's Manual

SIgnal cable FRU12-05AFFM (Main Alarm Panel)
6
Connect cores
to WAGO terminal block. Vinyl tape
80 mm
Wrap wires with
vinyl tape.
How to fabricate cables for processor unit
4.7.2

Wiring information

Item
Operator fitness
FRU12-05AFFM
(between BR-510 and
BR-520)
Cable MPYC-7
(between BR-530/550
and BR-520)
Motion Detector
BR-560
INPUT2 (TB17)
50
10 10
Set this part
in cable clamp.
80 mm
Wrap armor with
vinyl tape.
• FAR-2105: It is not possible to create a connection for operator fitness
between FAR-2105 and the Processor Unit, because the FAR-2105
does not have operator fitness output.
• FAR-2107: Use port J612 (#7/8 for operator fitness), where a contact
signal is available.
• Other makes of radars: Check for availability of contact signal.
This cable is fit with a Micro-C connector (male) on one end and a stripped
end for connection to the BR-520. The standard length is 6 m. 10 m, 20 m,
30 m, 40 m, and 50 m cables are optionally available.
40 m and the total length for all units is max. 150 m. For example, when
four BR-530 are installed: No.1 BR-530: 40 m No. 2 BR-530: 40 m No. 3
BR-530: 40 m No. 4 BR-530: 30 m Total length: 150 m
• Pyroelectric detection
• Detection range: Up to 5m, 80°×80°
• Detection rate: 0.8 thru 1.2 m/s
• Detection sensitivity: 4°C (difference from surround in temperature)
Generally, up to two Motion Detectors can be installed, at INPUT3/4 and
INPUT5-8. Also, INPUT port 2 can be used by setting [INPUT2] on the Ser-
vice menu to [Timer Reset].
Backup Navigator signal or Timer Reset signal (operator fitness, motion
detector) can be connected to the INPUT Port 2. Select the signal from the
Service menu. When the Backup navigator mode is used, set the external
equipment's output signals as follows: Power off: CLOSE, Normal working:
CLOSE, Alarm generated: OPEN
Fix cables to post with cable tie
Description
4. INSTALLATION
4-13