How To Fabricate Cables For The Cabin Panel, Timer Reset Panel, Flash Beacon; Dip Switch, Rotary Switch Settings - Furuno BR-500 Operator's Manual

4. INSTALLATION
4.7.6 How to fabricate cables for the Cabin Panel, Timer Reset Panel,
Flash Beacon and Motion Detector
Fabricate the above-mentioned cables as shown below.
Connect cores to
WAGO terminal block.
4.8

DIP Switch, Rotary Switch Settings

A DIP switch and a Rotary switch are provided in the Processor Unit to adjust the
equipment according to applicable regulations and ship's requirements.
Location of switches in the Processor Unit
DIP SW S1
ON
1 2 3 4 5 6 7 8
4-16
Sheath
Armor
Cut sheath. Remove paint approx. 50 mm.
Vinyl
tape
L=Length between cable
clamp and terminal
Set this part
in cable clamp.
Rotary SW S2
SW position
Default setting in bold italic
Frequency
0 4.2 kHz
1 4.15 kHz
2 4.25 kHz
3 4.2 kHz
4 4.2 kHz
5 4.2 kHz
6 4.2 kHz
7 4.2 kHz
8 4.2 kHz
9 4.2 kHz
0 4.2 kHz
A 4.2 kHz
B 4.2 kHz
C 4.2 kHz
D 4.2 kHz
E 4.2 kHz
F 4.2 kHz