Furuno BR-500 Operator's Manual page 53

How to change the password
1. Use the CursorPad to select [Password] from the Administrator menu then press
the ENT/CALL key.
2. Select [Change Password], then press the ENT/CALL key. The Input new pass-
word box is highlighted in yellow.
3. Set the password using a combination of the following keys; MENU/ESC, ENT/
CALL, up arrow, down arrow, left arrow, right arrow.
Each key press changes the displayed characters to asterisks "*". A total of six
character must be input for the new password.
4. After the sixth character is input, the cursor moves to the Confirm Password box
and the box is highlighted in yellow. Input the password set at step 2.
5. If the passwords input at step 2 and step 3 match, a pop up message confirming
the change is displayed.
Possible error messages and their meaning:
1. "Password invalid Use a different password" - The characters used for the pass-
word are invalid, repeat the process from step 1.
2. "Passwords do not match Failed to change password" - The passwords set at step
2 and step 3 are not the same. Repeat the process using the same password for
step 2 and step 3.
How to reset the password to factory default:
1. Select [Reset Password], then press the ENT/CALL key. A confirmation pop up
is displayed.
2. Select [Yes] to reset the password, [No] to cancel, then press the ENT/CALL key.
4. INSTALLATION
4-21