Alarm - JRC JLN-205MK2 Quick Reference

5.2 Alarm

Check the alarm details referring to the list shown below.
Alarm List
1) Common
Message
Number
45 ROM[1]
46 ROM[2]
47 ROM[3]
48 RAM
49 SIO[0]
50 SIO[1]
51 SIO[2]
52 SIO[3]
53 SIO[6]
- No Sensor Data
- Sensor Data Invalid
2) MID
Message
Number
2/3/7 SOG/STW/SOG(LOG)
10 TRIP
17 WATER TEMP
18 DEPTH
19/20 TWS/AWS
21 AIR TEMP
22 PRESSURE
23 HUMIDITY
3) Doppler Log
Message
Number
63 STW Lost
3/4/7 STW/SOG(GPS)/
SOG(LOG)
10 TRIP
54 NG:URT Data Lost
55 NG:Disp RxT Data
56 NG:Proc RxT Data
57 NG:Tmnl TxD TB
58 NG:Tmnl TxD Pin
59 NG:Tmnl RxD Pin
60 NG:Tmnl TxP Pin
61 NG:Tmnl TxP TB
62
NG:Tmnl RxP Pin
Message Contents
Message Contents
Message Contents
Alarm Causes
Flash ROM Deletion, Write Error (ROM[1])
Flash ROM Deletion, Write Error (ROM[2])
SEEPROM Deletion, Write Error
RAM Read, Write Error
Serial Port Error (SIO[0])
Serial Port Error (SIO[1])
Serial Port Error (SIO[2])
Serial Port Error (SIO[3])
Serial Port Error (SIO[6])
Sensor periodic input not possible (No data)
Sensor information unobtainable (Position, Time,
Course, etc.)
Alarm Causes
Speed alarm occurs
Trip alarm occurs
Water Temperature alarm occurs
Depth alarm occurs
Wind alarm occurs
Air temperature occurs
Pressure alarm occurs
humidity alarm occurs
Alarm Causes
The vessel speed cannot be computed.
The vessel speed is within the alarm range that is
set.
The trip value is within the alarm range that is set.
URT Data is lost.
The display data cannot be obtained in the display
unit.
A measurement condition is not set in the processor.
There is no display data to the display unit on the
terminal in the distributor.
There is no display data to the display unit in the
distributor.
Signals from the display unit are not delivered to the
distributor.
There is no signal to the processor in the distributor.
There is no signal to the processor in the terminal of
the distributor.
Signals from the processor are not delivered to the
distributor.
5-3