Mounting Using A Flush Mount - JRC JLN-205MK2 Quick Reference

6.2.3 Mounting using a flush mount

Use the following procedure.
See the diagram below for the mounting space and mounting holes.
Do not tighten a screw too much. Doing so may result in damage of installation holes.
1) Insert the main unit in the installation location.
2) Fix the main unit using the mounting screws (φ4 screw or wood screw, L>=10mm, provided by
the shipyard).
The sizes of the heads of the screws that are used are restricted as follows including the
washers.
 Diameter: Up to 8 mm
 Height: Up to 4.5 mm
3) Insert the front panel into the main unit
Front panel
6-6
4.5
Mounting
mounting
screw
hole (4)
(provided by
the shipyard)
Main unit Mounting wall
After mounting